Resetting the Datalogic Gryphon to Factory Default or Custom Settings
To reset Datalogic Gryphon settings to factory defaults, you will need to scan the accompanying barcode to reset your device.
Please note that these barcodes may not correspond with every Gryphon scanner, as there are several models. Please refer to the Gryphon 4400 user manual or the Gryphon 4500 user manual.
Enter/Exit Program Mode
To reset your Gryphon scanner using the following barcodes, you’ll need to enter the device into programming mode. Please scan the following barcode to enter or exit Programming mode on your Datalogic Gryphon barcode scanner.
How to Restore Custom Defaults for GD4400
If you aren’t sure what programming options are in your Gryphon imager, or you have changed some options and want to restore the Custom Default Configuration, scan the Restore Custom Default Configuration barcode below. This will restore the custom configuration for the currently active interface.
Restore Factory Default Configuration
If you want to restore the Default Factory Configuration on your Datalogic Gryphon, scan either the Restore USA Factory Configuration barcode or the Restore EU Factory Configuration barcode below. Both labels restore the scanner configuration to the factory default settings, including interface type. The USA label restores Label IDs to those historically used in the USA. The EU label restores Label IDs to those historically used in Europe.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces by scanning the following label.
Troubleshooting a GD4400 or GD4500 series can be tough. Ask us about our Datalogic Gryphon repair programs today.
Request a Quote
"*" indicates required fields