Installing the Interface Cable in your Motorola LS3408
Loosen the screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from the bottom of the scanner.
Open the clamp and plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle.
Gently tug the cable to ensure the connector is properly secured.
Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the bottom of the scanner.
Connect the other end of the interface cable to the host.
Note: Different hosts require different cables. The connectors illustrated above may be different than illustrated above but the steps to connect the scanner are the same.